Is the cleaning of the advertising engraving machine used after use?

1. Once the work is finished, the countertop should be cleaned in time to facilitate the next work.

2. Clean the material scraps along the guide rails and guide rails to prevent the machine from being disturbed by debris and the phenomenon of the card machine in the working process.

3. Regularly clean the lead screw to prevent foreign matter from sticking on the lead screw. The lead screw is very important in the equipment, which determines the accuracy of the machine.

4, regularly clean the industrial control box, dust is the biggest killer of the circuit board.

How to apply oil before using the advertising engraving machine?

1. First clean the guide rails and lead screws, and clean the oil and material scraps on the guide rails and the lead screws with a cloth that does not remove the hair. Due to the low temperature, both the guide rail and the lead screw can be added with oil. It is best to add antifreeze oil.

2. The refueling cycle is twice a month, that is, every two weeks.

3. If the machine is not used for a long time, it should be refueled regularly to ensure the flexibility of the transmission system.

4. After the oil is added, move slowly back and forth to ensure that the lubricant can be evenly applied to the guide rail and the lead screw.

What are the precautions for using the cooling water in the advertising engraving machine?

1. Cooling water is a necessary condition for the normal operation of the spindle motor. If the cooling water is too dirty, it will cause serious damage to the motor. Therefore, the cooling water must be cleaned to ensure the normal operation of the pump.

2, pay attention to the water level, must not make the water-cooled spindle motor water shortage, so that the motor heat can not be exported in time.

3, pay attention to the ambient temperature, be careful because the water temperature is too cold and cause the water tank and water pipe to freeze.

4. Conditional antifreeze can be used for cooling.

Computer maintenance before the use of advertising engraving machine?

1. Clean the dust of the chassis regularly, pay attention to the heat dissipation of the chassis, and be careful that the industrial control card is faulty due to excessive dust.

2. Regularly defragment the disk and optimize the computer system.

3, regularly check and kill the virus, but pay attention to work can not open the anti-virus program to prevent interference work.