1, the cleaning of the bearing
When disassembling the lower bearing for inspection, first record the appearance of the bearing, confirm the residual amount of the lubricant, and clean the bearing after sampling the lubricant for inspection. As a cleaning agent, gasoline and kerosene are commonly used.
The cleaning of the removed bearing is divided into coarse cleaning and fine fine washing. In the container, the metal mesh bottom is placed first, so that the bearing does not directly contact the container. When rough cleaning, if the bearing is rotated with dirt, it will damage the rolling surface of the bearing and should be noted. In the rough cleaning, use a brush to remove the grease and adhesive. After it is almost clean, it is transferred to the fine wash. Fine washing is to carefully clean the bearing while rotating it in the cleaning solution. In addition, the cleaning oil should always be kept clean.
2. Inspection and judgment of bearings
In order to judge whether the removed bearing can be reused, check the bearing after cleaning, carefully check the raceway surface, the rolling surface, the state of the mating surface, the wear of the cage, the increase of the bearing clearance and whether there is dimensional accuracy. Falling damage, abnormality. For non-separable ball bearings, use one hand to support the inner ring horizontally, and turn the outer ring to check if it is in a smooth rotation.
Separate bearings such as tapered roller bearings can be inspected separately for the rolling surfaces of the rolling elements and the outer ring.
Large bearings cannot be rotated by hand. Pay attention to the appearance of rolling elements, raceways, cages, ribs, etc. The higher the importance, the more careful inspection is required.
The judgment of whether or not to reuse is determined in consideration of the degree of bearing damage, mechanical properties, importance, operating conditions, and the period until the next inspection. However, if there are the following defects, they can no longer be used, and new bearings must be replaced:
(a) cracks or notches on any of the inner ring, the outer ring, the rolling elements, and the cage;
(b) rupture on any of the ferrules and rolling elements;
(c) Significant jams on the raceway surface, ribs and rolling elements;
(d) the cage is worn significantly or the rivet is significantly slack;
(e) There is rust and injury on the raceway surface and the rolling elements;
(f) There are severe indentations and marks on the raceway surface and rolling elements;
(g) The inner diameter of the inner ring or the outer diameter of the outer ring has obvious creep;
(h) discoloration due to heat;
(i) Bearings sealed with grease, the seal or dust cover is damaged.
For more information and purchase please visit: https://www.supplyforever.com
